European Union tariff lines under HS 8481.80

The European Union tariff splits HS 8481.80 (other appliances) into 40 national lines: 8481 80 11 10 (for use in certain types of aircraft), 8481 80 11 90 (other), 8481 80 19 10 (for use in certain types of aircraft), 8481 80 19 90 (other) and 36 others. The general (MFN) duty is 2.2% on all 40 lines.

• 8481 80 11 10For use in certain types of aircraftDuty: 2.2%
• 8481 80 11 90OtherDuty: 2.2%
• 8481 80 19 10For use in certain types of aircraftDuty: 2.2%
• 8481 80 19 90OtherDuty: 2.2%
• 8481 80 31 00Thermostatic valvesDuty: 2.2%
• 8481 80 39 00OtherDuty: 2.2%
• 8481 80 40 10For use in certain types of aircraftDuty: 2.2%
• 8481 80 40 90OtherDuty: 2.2%
• 8481 80 51 00Temperature regulatorsDuty: 2.2%
• 8481 80 59 20Pressure regulating valve for incorporation into compressors of motor vehicle air condition unitsDuty: 2.2%
• 8481 80 59 30Two-way flow control valve with housing, with: - at least 5, but not more than 16 outlet holes with at least 0,05 mm, but not more than 0,5 mm diameter, - at least 330 cm³/minute, but not more than 5 000 cm³/minute flow rate, - at least 19, but not more than 300 MPa operating pressureDuty: 2.2%
• 8481 80 59 40Flow-control valve - made of steel, - with an outlet hole with a diameter of at least 0,05mm or more, but not more than 0,5 mm, - with an inlet hole with a diameter of at least 0,1 mm, but not more than 1,3 mm, - with chromium nitride coating, - with a surface roughness of Rp 0,4Duty: 2.2%
• 8481 80 59 50Electromagnetic valve for quantity control with - a plunger, - a solenoid with a of coil resistance of at least 1,85 Ohm, but not more than 8,2 OhmDuty: 2.2%
• 8481 80 59 60Electromagnetic valve for quantity control - with a solenoid with a coil resistance of at least 0,19 Ohm, but not more than 0,66 Ohm, and with an inductance of not more than 1 mHDuty: 2.2%
• 8481 80 59 70Flow-control valve -made of steel, -with an outlet hole with a diameter of at least 0,05 mm, but not more than 0,5 mm, -with an inlet hole with a diameter of at least 0,1 mm, but not more than 1,3 mmDuty: 2.2%
• 8481 80 59 80Solenoid valve for combustion engine oil pump to regulate the quantity of oil in the pump: -with a cable of length of 550 mm or more but not more than 700 mm incorporating an electrical connector, -with an operating pressure of not more than 5.5 bar, -with an operating voltage of 9 VDC or more but not more than 16 VDC, -with a valve's base width of 22 mm or more but not more than 27 mm, -with a valve's length of 55 mm or more but not more than 110 mm, for use in the manufacture of motor vehicle enginesDuty: 2.2%
• 8481 80 59 90OtherDuty: 2.2%
• 8481 80 61 00Of cast ironDuty: 2.2%
• 8481 80 63 50For use in certain types of aircraftDuty: 2.2%
• 8481 80 63 90OtherDuty: 2.2%
• 8481 80 69 50For use in certain types of aircraftDuty: 2.2%
• 8481 80 69 60Four-way reversing valve for refrigerants, consisting of: - a solenoid pilot valve - a brass valve body including valve slider and copper connections with a working pressure up to 4,5 MPaDuty: 2.2%
• 8481 80 69 99OtherDuty: 2.2%
• 8481 80 71 00Of cast ironDuty: 2.2%
• 8481 80 73 10For use in certain types of aircraftDuty: 2.2%
• 8481 80 73 20Pressure- and flow-control valve controlled by external electromagnet: - made of steel and/or steel alloy(s), - without integrated circuit, - of not more than 1000 kPa operating pressure, - with a flow quantity of not more than 5 l/min, - without an electromagnetDuty: 2.2%
• 8481 80 73 90OtherDuty: 2.2%
• 8481 80 79 10For use in certain types of aircraftDuty: 2.2%
• 8481 80 79 40Service valve which suits for R410A or R32 gas while connecting indoor and outdoor units with: -a withstanding pressure of the valve body of 6,3 MPa, -a leakage ratio of less than 1.6 g/a, -an impurity ratio of less than 1.2 mg/PCS, -an airtight pressure of the valve body of 4.2 Mpa for use in the manufacture of air conditionersDuty: 2.2%
• 8481 80 79 90OtherDuty: 2.2%
• 8481 80 81 30For use in certain types of aircraftDuty: 2.2%
• 8481 80 81 90OtherDuty: 2.2%
• 8481 80 85 30For use in certain types of aircraftDuty: 2.2%
• 8481 80 85 90OtherDuty: 2.2%
• 8481 80 87 30For use in certain types of aircraftDuty: 2.2%
• 8481 80 87 90OtherDuty: 2.2%
• 8481 80 99 40For use in certain types of aircraftDuty: 2.2%
• 8481 80 99 70Pressure- and flow-control valve controlled by external electromagnet: - made of steel and/or steel alloy(s), - without integrated circuit, - of not more than 1000 kPa operating pressure, - with a flow quantity of not more than 5 l/min, - without an electromagnetDuty: 2.2%
• 8481 80 99 80Solenoid valve for combustion engine continuous variable valve timing system to control oil flow as a function of engine speed and load: -in metal cover, -with electrical connector, -with a force of not more than 10 N, -with an operating voltage of 9 VDC or more but not more than 16 VDC, -with a length of 80 mm or more but not more than 110 mm, -with a width of 80 mm or more but not more than 110 mm, -with a height of 20 mm or more but not more than 30 mm, for use in the manufacture of engines of motor vehiclesDuty: 2.2%
• 8481 80 99 90OtherDuty: 2.2%

• United States35 lines, used by 1 other country

The Harmonized System text for 8481.80